Easyblinds - Fabric Fastener Strips

These fabric fastener loop strips are for use with our easynight blackout blinds and fabric.

Self-adhesive, when these strips are stuck to easynight blackout fabric it can be attached to easynight suction cups or velcro.

Please note you are purchasing only the accessory NOT the blinds. 

Here is some important info to read prior to putting the blinds up:

1. The window frame must be completely clean and dry.  Some cleaning products can leave a residue behind so we recommend rinsing the frame with water after cleaning, and allowing it to dry completely.
2. It's important to place the strip correctly the first time, as removing and re-positioning weakens the adhesive. I also found placing the velcro pads higher and closer to the edge of the blind than the photograph shows on the instruction booklet made a firmer grip so the blind could not flop over and let light sneak in. For additional protection against peeping light you can use the 3M Command strips (not included) and place these strips in the corners of the windowsill as shown in the photographs.
3. Please use all self-adhesive pads evenly to distribute the weight of the blind.  When placing the sticky pads on the blinds, make sure this is on the silver backing, press firmly and leave 24 hours so the special fibre can adhere to the blind.  

A more thorough FAQ page can be located on our suppliers page including detailed measurements, and the differences between the blinds.