Harry Potter inspired cookie 3Dbosser

3Dmbossers are designed to push all the fondant down around the image to leave the image standing up. The technique gives the appearance of having perfectly placed cut fondant stuck on the cookie without needing all the time and patience to do.

Our round 3Dmbosser plates are 75mm wide and are designed to be used with a 70mm round cutter.

There is no handle added to the back of these so it easier to apply pressure with a rolling pin.

Made in Australia. Made from PLA which is a biodegradable plastic derived from renewable resources including cornstarch, sugar cane, tapioca roots or even potato starch.

Hand wash only, keep below 50 degrees/c (122 degrees/f)

DO NOT wash in dishwasher.

All designs are Copyright protected and can not be copied. Designs have either been designed by Custom Cookie Cutters or commercial licences have been purchased by the designer.